STan94 wrote:Thanks for the tips, although it left me more confused because I'm not very knowledgeable of the names of different bricks or parts of a motorcycle so it's really my bad. It seems like the only way I'm gonna add the big wheels is if I cut off some parts of the motorcycle chassis. I'm gonna buy that motorcycle breakout soon and do my own experimenting.
I'm not sure of the names I used for the parts so it might be totally normal that you didn't recongnize them.
Parts don't have names they have part numbers. Which I don't really know. I suppose I could look them up in the instruction books.
For your particular build. You could probably use what I called a double angle peg.
Which is basically a solid bent pipe. Its shaped like the letter Z
You can use two of those to make your front forks wider.
The fork is the part of the bike that holds the wheel (in case you did not know or its called something else where you live)
As for the back, I think the only way to use that bike frame is to cut the end of it.
For both front and back you will need to find some larger wheels.
Finding the wheels will probably be the most difficult part (assuming you stay with MB parts). You need to find a large wheel that has a hole on both sides of it. If you don't then you will have to drill the hole yourself.
One thing to keep in mind about MB wheels is that even if you do find a wheel (rim) with holes on both sides, the distance from the inner to outer rim on each side tends to be slightly different.
I hope this clarified a few things rather than adding to the confusion ;p
Can't wait to see your build. Good luck.