I told some of you I couldn’t do DIY stuff with my figs.
Y’ALL BEEN FOOLED.
This is my custom sword. It’s creation requires the following materials.
2x tooth picks (Extra in case you mess up. If you mess up more than once, you need help.)
1x Lighter
Tape
Step 1: Light toothpick on fire and let the tooth pick burn to desired length. (Why burn it? Burning instead of cutting w/scissors leaves less likelihood of splinters. Plus fire is fun!)
Step 2: After toothpick has cooled, wrap tape around burnt end until you think it might fit in a figure’s hand.
Step 3: Test hilt width on figure. If the hilt is too wide or too skinny, wrap or unwrap tape to change. Repeat this process till the perfect hilt is achieved.
Now you have a sword! You can paint it, but I prefer to show people how low budget I am.
Enjoy!
Y’ALL BEEN FOOLED.
This is my custom sword. It’s creation requires the following materials.
2x tooth picks (Extra in case you mess up. If you mess up more than once, you need help.)
1x Lighter
Tape
Step 1: Light toothpick on fire and let the tooth pick burn to desired length. (Why burn it? Burning instead of cutting w/scissors leaves less likelihood of splinters. Plus fire is fun!)
Step 2: After toothpick has cooled, wrap tape around burnt end until you think it might fit in a figure’s hand.
Step 3: Test hilt width on figure. If the hilt is too wide or too skinny, wrap or unwrap tape to change. Repeat this process till the perfect hilt is achieved.
Now you have a sword! You can paint it, but I prefer to show people how low budget I am.
Enjoy!