As @yunnim suggested, this a tutorial on how to make a paper drop pod-PLEASE NOTE: it'll take a little effort to get everything to work, and it wont be that sturdy
First, draw the shape of the drop pod(reccomendedly using a ruler for straight lines)
Now, cut it out. Put the piece to the side, and use the scrap as a stencil. This makes it easier to make 3 more pieces
After cutting those out, take one piece. Cut out a door shape in the middle. Use a piece of tape to connect it to the inside/outside of the part you cut out.
Use tape to connect all the peices, or wait till these steps are done to make thing a wee bit easier:
Measure one edge of the drop ship. On the bottom. Make a 2 squares to accommodate this size.
On one square, do a smaller square inside. Cut a line from the corner to the square. Do this on all sides. Then, fold the sides inward. Connect the flat square on the top(after this OPTIONAL step: poke a whole in the square. More on this at the end of desc)
The other square goes on the bottom.
OPTIONAL: if you decided to make that hole, then do this: take a thin piece of paper, and fold it. Then, squish the top and bottom.
Make a small square, and poke a hole in the middle. Stick it on the paper strip.(after making four parachute wings)
Stick the the strip on the top.[may be hard]
As I said before, it wont be sturdy, unless you use cardboard, which is slightly different. If you need better instructions, please ask.
First, draw the shape of the drop pod(reccomendedly using a ruler for straight lines)
Now, cut it out. Put the piece to the side, and use the scrap as a stencil. This makes it easier to make 3 more pieces
After cutting those out, take one piece. Cut out a door shape in the middle. Use a piece of tape to connect it to the inside/outside of the part you cut out.
Use tape to connect all the peices, or wait till these steps are done to make thing a wee bit easier:
Measure one edge of the drop ship. On the bottom. Make a 2 squares to accommodate this size.
On one square, do a smaller square inside. Cut a line from the corner to the square. Do this on all sides. Then, fold the sides inward. Connect the flat square on the top(after this OPTIONAL step: poke a whole in the square. More on this at the end of desc)
The other square goes on the bottom.
OPTIONAL: if you decided to make that hole, then do this: take a thin piece of paper, and fold it. Then, squish the top and bottom.
Make a small square, and poke a hole in the middle. Stick it on the paper strip.(after making four parachute wings)
Stick the the strip on the top.[may be hard]
As I said before, it wont be sturdy, unless you use cardboard, which is slightly different. If you need better instructions, please ask.